1995 BMW 325IS

○ Not enough data
1995 BMW 325IS
RENDERED 2026-11-01T12:48:57.265Z

Only 5 complaints on file — too few for a fair verdict.

This verdict reflects complaint volume compared to this model's typical year. Recalls and safety issues below apply regardless of the verdict — always check them.

Only 5 complaints on file — too few for a fair verdict. The data below is complete but unranked.

Complaints
5

Too few to rank

Recalls
2

Campaigns on file for 1995

Investigations
0

None on file

Top problem
—

Not enough data

Complaints per year

1992: 8 complaints 1992 1993: 16 complaints 1993 1994: 10 complaints 1994 1995: 5 complaints 1995 5
1992: 8 complaints 1992 1993: 16 complaints 1993 1994: 10 complaints 1994 1995: 5 complaints 1995 5
1992: 8 complaints 1992 1993: 16 complaints 1993 1994: 10 complaints 1994 1995: 5 complaints 1995 5

1995: 5 complaints

View as data table
YearComplaints
19928
199316
199410
19955

Known problem areas

Only 5 complaints on file for this model year — too few to rank by share. Raw counts only, below.

Engine and engine cooling

4 of 5 total reports mention: engine and engine cooling, most commonly citing cooling system and engine.

Show complaint excerpts

The radiator malfunctioned about a month ago. It was fixed by an independent mechanic. Consumer noticed that this has happened to other consumers in the area.

NHTSA ODI report, 2003-07-17

Consumer received recall 98V178000/ manufacturer's recall # same/ coolant system. Consumer took vehicle to ferma BMW on US19 in safety harbor, Florida where they denied doing recall work.

NHTSA ODI report, 2001-05-10

Suspension

1 of 5 total reports mentions: suspension, most commonly citing rear.

Show complaint excerpts

Dt*: the contact stated while backing up out of a driveway at 5 MPH, a noise was heard. The contact inspected the vehicle and noticed the rear passenger side wheel separated from the control arm support.

NHTSA ODI report, 2006-12-05

Equipment

1 of 5 total reports mentions: equipment.

Air bags

1 of 5 total reports mentions: air bags, most commonly citing frontal.

CRASHINJURY
Show complaint excerpts

The vehicle was involved in a frontal collision, and the air bags failed to deploy, the consumer was injured.

NHTSA ODI report, 2003-03-17

Safety timeline

2 recalls · 0 investigations · oldest first

To check one car, enter its VIN on the NHTSA recall page. Check a VIN →

  1. R
    1997-10-30Vehicle speed control97V131000 The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to…

    Remedy: Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from…

  2. R
    1999-03-31Engine and engine cooling98V178000 Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant…

    Remedy: Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.

Buy-smart checklist

1995 BMW 325IS — pre-purchase inspection

Inspect

  • Engine and engine cooling: 4 reports on file for this year.
  • Suspension: 1 report on file for this year.
  • Equipment: 1 report on file for this year.

Verify these recalls were completed

  • Recall 97V131000 · Vehicle speed control
  • Recall 98V178000 · Engine and engine cooling

FAQ

Is the 1995 BMW 325IS reliable?
There isn't enough NHTSA complaint data on file yet to give this model year a verdict.
What are the most common problems with the 1995 BMW 325IS?
The most-reported component is engine and engine cooling, accounting for 80% of complaints on file.
How many recalls does the 1995 BMW 325IS have?
2 recalls on file for this model year.

Data updated 2026-11-01 · Complaints are unverified owner reports filed with NHTSA, not independently verified defects. Methodology.